ShowerBreeze Installation Video

NOTE: You DO NOT need a wrench TO INSTALL this product!

1: Remove your showerhead (A) from the shower pipe (B).

Wrap a piece of plumbers tape (included) twice clockwise around the shower pipe threads (B). Pull tight enough to draw the tape down into the threads.

Then screw on your ShowerBreeze diverter valve (C) clockwise by hand onto the shower pipe until it's tight. (You do NOT need a wrench.

2: Wrap plumbers tape around the ShowerBreeze diverter valve threads (D).

3: Then, screw your showerhead onto the diverter valve and tighten by hand.

4: Attach your hand-held pik (E) to the connector at the end of the hose (F) by pressing and turning until it locks into place. (Do not force it. It should easily slide in and lock in place.)

5: Turn on the shower; divert the water flow to your Pik by slowly switching the lever (G) on the side of the diverter valve until the desired pressure is reached. You're now ready to use your ShowerBreeze. After using it, make sure to switch your diverter back to regular shower spray.