QuickBreeze Installation

Before installing your QuickBreeze, unscrew your aerator at the tip of the sink faucet by twisting to the RIGHT (as you look down from above) clockwise.

Remove it and then clean the faucet threads with a cloth. You "may" need pliers and a cloth to remove your old aerator, but try with your hands first.

Replace removed aerator with provided adaptor/aerator.

Screw into place by twisting to the LEFT    counter-clockwise, and tighten using your hand.

You do not need tools to install the new adaptor/aerator. Using pliers with break it, and you will void your guarantee. Check water flow, it should flow normally

Remove your Breeze from the box, and place the enclosed items on sink in this order.

•  Adapter & washer

•  Valve and Tube Connector

•  Tips

If your faucet has "inside" threads, insert large (included-below) washer before attaching adapter. If your faucet has outside threads, you will not need large included washer.

Step 1: Take valve and pull top GRIP RING down. Place valve over adapter and release GRIP RING. Valve and adapter will be attached. Tug gently on valve base to confirm.

Point tip connector into open sink drain and… SLOWLY turn on faucet! Very little water pressure is needed to be effective.

Water should run from connector into drain without leakage.

Turn off faucet.

Step 2: Attach colored tip by placing the end with the black ring all the way into the open end of the connector. Twist gently until it clicks into place. Very slowly turn on faucet until desired amount of temperature/pressure is attained. Turn off faucet. Twist gently until it clicks into place.

Step 5: Place tip in mouth and hold head over sink as if brushing teeth. Then very slowly turn on faucet until desired amount of pressure is attained.

When finished, turn off faucet, twist tip quarter turn and remove. Pull GRIP RING down and detach valve from adapter. Leave adapter attached to faucet. It will replace your original aerator.